HA enabled, Heartbeat Up, HA State synchronized Remote CP (Slot 6, CP0): Standby, Healthy Local CP (Slot 7, CP1): Active, Warm Recovered Perform hafailover, which will reboot the processor on the current active CP card, but not the switch (non-disruptive to fibre channel).Ĭheck to ensure HA status is enabled and synchronized, perform CP failover.
#SUPERDOME X BROCADE SAN SWITCH SERIAL#
Connect to the Active CP via the serial cable.Ī.
#SUPERDOME X BROCADE SAN SWITCH FULL#
If the user does NOT know if their IP switch can support 100/Full Duplex, then at this point we can leave the eth0 interface at 100/Full Duplex and test the connectivity. If the connectivity fails, change it back to the original setting.Ĭhange it back to the original duplex settingįorce 100 Mbps / Full Duplex (yes, y, no, n): įorce 100 Mbps / Half Duplex (yes, y, no, n): yġ. It is recommended that you only use this command from the serial console port.Īre you sure you really want to do this? (yes, y, no, n): yįorce 100 Mbps / Full Duplex (yes, y, no, n): y Note: As per Brocade it is recommended that the eth0 interface be running at 100/Full Duplex (assuming the IP network switch can support it).Įxercise care when using this command. Forcing the link to an operating mode not supported by the network equipment to which it is attached may result in an inability to communicate with the system through its ethernet interface. Link mode: 100 Mbit, half duplex, link okĬhange the following to the opposite of the above output, in our case change it to 100/Full duplex. Change IP address of the switch and then change it back to the original IP.Ĭhange the IP settings back to factory defaultĮthernet IP Address :xx.xx.xx.xxĮthernet Subnetmask :xxx.x.x.xĮthernet Subnetmask : Perform hareboot, which will reboot the processor, but not the switch (non-disruptive to fibre channel)ī. Reset eth0 using one of the options below (options are listed in recommended order from Brocade).Ī. Connect to the switch via serial cable.Ģ. NOTE: The workarounds below are considered non-disruptive, however it is recommended that the action plan be carried out during a customer window in case an unexpected reboot occurs.ġ. Workaround for both Director and Departmental switch: Warning: D o not perform "ifconfig eth0 down" command to bring down the Ethernet port as it may cause panic or reboot on departmental class switch or unexpected HAfailover on Director class switch.
0 kommentar(er)
